FlexiLib

This is a web server written with the following goals:

• Low memory consumption
• Low latency
• Flexible "reverse proxy" capabilities
• Ability to simulate FAAS capabilities of various online providers (AWS, CloudFlare, etc)

This last point is indirectly supported through the ability of the server to load, at run time, dynamic libraries to support requests. It will also reload these libraries after any in flight requests have completed, to support the experience of developing new libaries.

Libraries can be written in any programming language that supports a standard Linux C-Based calling convention, which is to say, nearly every programming language.

This project provides slightly better development and performance characteristics if the library used is written in zig. An example zig-based library can be found in src/main-lib.zig.

Architecture

This library assumes the use of Linux as a host. While the primary engine is not tied to Linux, the file watcher module uses inotify and friends and will not work outside that OS. PRs are welcome.

The system is built with a pre-release version of zig, currently zig version 0.11.0-dev.3886+0c1bfe271. This version has web server in the standard library, so it is useful.

To achieve the lowest latency possible, this server loads dynamic libraries using dlopen(3) based on a configuration file in the current working directory called proxy.ini. An example of the configuration is in this directory, and it is relatively simple string prefix matching, again, for speed.

On startup, a thread pool will be created. Request paths and header matching is loaded from the configuration file, and file watches are initiated on all libraries mentioned in the configuration file. Libraries are loaded on demand when a request arrives that needs the library. When a library changes for a new version, the file watcher will take note and unload the previous version.

Changes to the configuration file are not watched, relying instead on a HUP signal to force a reload. At that point, all libraries ("executors") are unloaded, and configuration is re-read.

As libraries are loaded directly into main process space, bugs in the libraries can and will crash the engine. As such, some supervisory process (dockerd, systemd, etc) should monitor and restart if necessary.

Security

There is little attempt to secure libraries from interfering with the current thread or even the main process. As such, the libraries should be fully trusted. However, libraries themselves may be hardened to run other non-trusted code. For example: A "I run WASM code" library may be written to create a WASM VM and run user-supplied WASM code. In that case, the "I run WASM code" library is trusted, although the code it runs may not be.

Configuration

Very little has been done so far in terms of configuration. By default, the number of threads created to serve requests is equal to the number of CPUs reported by the system (although thread count is limited to 4 threads when compiled in debug mode). This can be controlled with the environment variable SERVER_THREAD_COUNT.

The port by default is 8069, although this can be set with the PORT environment variable. Future plans include an environment variable for IP address as well as the amount of pre-allocated memory for response data (currently hardcoded to 8k/thread). Pre-allocated memory reduces the number of system calls required for memory allocation, and pre-allocation/allocation statistics per request are reported in the logs. The current pre-allocation provides approximately 4k per request without requiring system calls.

Logs

Request logs are sent to standard out, and are likely to change. Here is a sample:

127.0.0.1:59940 - - "GET / HTTP/1.1" 200 ttfb 2000.420ms 11 ttlb 2000.568ms (pre-alloc: 1569, alloc: 4350)

The first part mirrors common logs from Apache/nginx.

ttfb: Time to first byte. This represents the number of ms of processing within the library ttlb: Time to last byte. This includes processing as well a transmission of data pre-alloc: The amount of memory actually pre-allocated (1k is just a minimum and the system may allocate more) alloc: The amount of memory actually allocated during the request